Fluke TLK-220 SureGrip Industrial Test Lead Kit with Zippered Vinyl Carry Case

Special value SureGrip Set for industrial applications. It includes test leads and a roomy carry case to hold and protect your meter, two sizes of alligator clips and sharp test probes for reliable connections, and all your accessories. All 1000V CAT III, 600V CAT IV rated. Handy all-in-one kit.

1.Two 4-ft test leads, shrouded right-angle male banana connector to stainless steel test probe; rated 1000v 10A 



2. Two 1-meter modular test leads, shrouded right-angle male banana connector to straight shrouded male banana connector, 10A 



3. Two female-female banana test lead coupler (enables you to use the 1-meter modular leads to extend the 4-ft leads)



4.Two of each of the following slide-on adapters that fit the test probe on the 4-ft leads

_insulated alligator clip, 5A

_IC probe (thin), 3A

_insulation-piercing probe

_shroud; leaves only the tip of the probe exposed
 


5.Two of each of the following attachments that fit the straight male banana plug on the 1m modular leads: 

_test probe 

_insulated alligator clip, 5A

_bare spade lug

_claw clip with 26mm lead, 5A

_hook clip with 26mm lead, 5A



A nylon roll-up case with four translucent vinyl pockets to organize, carry, and protect the set. The top pocket, which holds the relatively-small test probe adapters for the 4-ft leads, has a Velcro closure, as does the case flap. It is compact and sized for this set, with no room for additions.